The design and production of automatic rubber roller covering machine is to improve and improve the lagging process. You can choose the right model for different industries. Advanced and mature equipment will bring higher efficiency to your production.
Features of rubber roller covering machine:
1. It is suitable for rubber roller production in heavy industry, such as steel deep processing, textile, printing and dyeing and other industrial transmission rubber rollers.
2. Equipped with e300cs powerful special 76 cold feed extruder and complete industrial refrigeration system;
3. Suitable for mixed rubber of various hardness;
4. The rubber roller can be selected to extend the coating function of special parts;
5. The general printing rubber roller can produce 40-60 pieces per shift.
Possible problems and solutions of rubber roller covering machine.
The machine does not move when it is first started:
1. The main power supply is not connected. Check the external power supply and re energize
2. The control power supply is not connected. Use the key switch to turn on the power supply or close the switch in the power distribution cabinet.
3. Press the pause button and press it again to pop it up
4. Press the emergency stop button and release the emergency stop button
5. PLC is damaged and replaced
6. Reconnect the power cord and other equipment to a separate power supply
Rotary table does not rotate:
1. The inverter is burnt out without display. replace
2. The inverter parameter setting is incorrect. Reset as required.
3. The turntable chain is broken. Adjust the distance between the sprockets and connect the chain. If the chain is damaged, replace the chain.
4. The turntable motor is faulty. Use a multimeter or vibrating screen to check whether the motor is missing or damaged. If it cannot be repaired on site, replace the motor.
5. The rotary table reducer is faulty, and it shall be replaced
6. The knob is damaged and the chassis is not rotated (E-type equipment) replacement
7. The programmable logic controller has no output to replace
8. The connection between rotary table reducer and sprocket is abnormal. Change connection plane key
The turntable of the winder needs to be pushed to start:
1. The starting time of the inverter slow start setting is too long. Reset it.
The turntable does not stop
1. Dip switch is damaged. Repair the dip switch.
The rotary table cannot be started or stopped slowly:
1. The inverter parameter setting is incorrect. Reset
Noise after rotating the rotary table:
1. The ground is uneven. The user needs to arrange or change the placement position.
2. Some idlers are seriously worn. Replace the idlers
The inverter displays an overload alarm and the voltage is unstable. Improve the power quality or adjust the frequency conversion acceleration and deceleration time.
Damage of active rubber roller and membrane frame connector (square bar):
1. If it is damaged during transportation, please replace it
2. Artificial collision and replacement
Film frame feed speed cannot be adjusted:
1. The DC speed control box is damaged and has no output.
2. If the single tray wheel is seriously worn, the support wheel shall be replaced.
Post time: Aug-11-2022
